plustek@linuxhacker.org

Only use the Plustek backend! Remove the epson line from dll.conf,
this scanner if produced by EPSON, but includes a chipset which is
supported by the Plustek backend - confusing? yes I know ;-)

Gerhard

On Donnerstag, 20. Februar 2003 08:56, Douglas Phillipson wrote:
> I'm using sane-backends-1.0.11 with a Epson Perfection 1250 USB scanner.
>
> The scanner shows up with "usbview" and sane-find-scanner:
>
> douglas@fastpc:~/sane-backends-1.0.11> sane-find-scanner
>
>
> found USB scanner (vendor=0x04b8, product=0x010f) at /dev/usb/scanner0
> found USB scanner (vendor=0x04b8, product=0x010f) at /dev/usbscanner
>    # Your USB scanner was detected. It may or may not be supported by
>    # SANE. Try scanimage -L and read the backend's manpage.
>
> But "scanimage" reports:
>
> scanimage -d epson:/dev/usb/scanner0
> [epson] The device at /dev/usb/scanner0 is not a supported EPSON scanner
> (product id=0x10f)
> [epson] Error opening the devicescanimage: open of device
> epson:/dev/usb/scanner0 failed: Invalid argument
>
> My /etc/sane.d/epson.conf reads:
>
> usb /dev/usb/scanner0
>
> My /etc/sane.d/plustek.conf reads:
>
> [usb] 0x04B8 0x010f
> device /dev/usbscanner
> option lampOff 0
> option warmup 10
>
> This scanner is in the compatibility chart.  Does anyone know what might
> be going on here?
>
> Thanks
>
> Doug Phillipson
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: plustek-unsubscribe@linuxhacker.org
> For additional commands, e-mail: plustek-help@linuxhacker.org