nanogui: touch screen
Subject:
Re: [nanogui] touch screen
From:
victor ####@####.####
Date:
15 Aug 2001 16:04:59 -0000
Message-Id: <3B7A9D92.312E8EBD@aaeon.com>
Hi,
I found out that if I change the screen_width and height in config, I
can get a resonable position on my screen using mou_ipaq driver. But I
have a problem that the "click" event is not very cleanly recongnize.
It's very hard for me to close the pop up window when I click the x spot
on the upper-right of the window. Do you have any idea to fix it??
And should I do the calibration? or just change the screen width and
height setting for the correct position.
thank you.
Jordan Crouse wrote:
>
> There are generally two types of Strongarm touchscreens. Most strongarm
> devices (I would say probably about 80%) use the UCB1x00 (usually the
> UCB1200). For these devices, use the ADSMOUSE. I have only seen one
> Strongarm device that does not use the UCB1x00, and thats the Ipaq. Alot of
> it depends on which touchscreen drivery you use in the kernel. If you use
> the h3600_ts driver, then use IPAQMOUSE, otherswise if you use ucb1200_ts,
> then use ADSMOUSE.
>
> Jordan
>
> On Tuesday 14 August 2001 15:27, victor mentioned:
> > Hi,
> > I am using a touch screen(DYNAPRO 95659) connected to my arm board to
> > access microwindows. Do you know which driver in microwindows should I
> > choose? Or where in the driver files of microwindows should I change?
> > I got a mouse error everytime I touch my screen.
> > But if I change the ipaq mouse driver a little bit, I can still access
> > the window with some kind of "shrinking" mapping so I am sure it should
> > be able to work with correct touch screen driver on microwindow.
> > Do you have any ideas, thanks??
> >
> > vic
> >
> > ---------------------------------------------------------------------
> > To unsubscribe, e-mail: ####@####.####
> > For additional commands, e-mail: ####@####.####
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: ####@####.####
> For additional commands, e-mail: ####@####.####