[<<] [<] Page 1 of 1 [>] [>>] | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Subject:
porting nano-X to a Technologic Systems TS-7390 ARM SBC
From: Jim Ham ####@####.#### Date: 26 May 2010 21:23:04 -0000 Message-Id: <4BFD912F.60302@porcine.com> This hardware comes with X Windows installed and uses the evtouch touchscreen driver. Can nano-X use this driver? If not, is one of the other nano-X supported drivers a good candidate for modifying? Has anyone else done this already? Regards, Jim Ham | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Subject:
Re: [nanogui] porting nano-X to a Technologic Systems TS-7390 ARM SBC
From: "Greg Haerr" ####@####.#### Date: 27 May 2010 04:43:00 -0000 Message-Id: <025d01cafd56$d3e670f0$6564a8c0@winXP> : This hardware comes with X Windows installed and uses the evtouch : touchscreen driver. Can nano-X use this driver? If not, is one of the : other nano-X supported drivers a good candidate for modifying? Has : anyone else done this already? I don't know anything about the evtouch software/hardware. Nano-X drivers are far simpler than any X11 drivers, but you may have to write your own. This is discussed in the Architecture document on the website. The existing touch drivers are in src/drivers/tou*.c. Regards, Greg | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
[<<] [<] Page 1 of 1 [>] [>>] |