primax: PXSCAN and the implementations...
Subject:
Re: PXSCAN and the implementations...
From:
Christian Ordig ####@####.####
Date:
15 Dec 2000 08:44:49 -0000
Message-Id: <20001215095314.A317@thor.chris.com>
On Thu, Dec 14, 2000 at 05:52:17PM -0600, Cederik De wrote:
> ASIC: 00
^^ here is where the problem is. It should be E3 (as the ASIC should
be called for the driver to work)
> scanner model reg= 18
hmmm... this also comes if you haven't connected your scanner? So it cannot
be the model ID ...
OK... I'd suggest opening the scanner's case and comparing the ICs found
in your scanner with those found in the "Parts" section of our project's
page. If they match the parts of the D9600 it should theoretically work.
DISCLAIMER: I AM NOT RESPONSIBLE FOR ANY DAMAGES RESULTING FROM OPENING YOUR
SCANNER! PLEASE ONLY DO IT IF YOU THINK YOU COULD COPE WITH A
SKREWDRIVER!
PS: please answer also to the list ... I am subscribed there and getting every
mail twice is quite annoying. Thanks.
--
Christian Ordig | Homepage: http://thor.prohosting.com/~chrordig/
Germany | eMail: Christian Ordig ####@####.####
[Content type application/pgp-signature not shown. Download]
