primax: please comment...


Previous by date: 7 Sep 2001 19:35:44 -0000 Re: Primax Scanner specifications, ricardo marcelo da silva
Next by date: 7 Sep 2001 19:35:44 -0000 Re: please comment..., Christian Ordig
Previous in thread:
Next in thread: 7 Sep 2001 19:35:44 -0000 Re: please comment..., Christian Ordig

Subject: please comment...
From: ####@####.#### (Michael Hoeller)
Date: 7 Sep 2001 19:35:44 -0000
Message-Id: <01090521545100.06015@tamboti>

Hello,

I posted this message a week ago on this list - and there was no response at 
all. Does that mean that there is no solution or is the traffic so low that 
it may take so long? 

Thanks a lot for any hint how I may get the scanne up and scanning
Michael

####@####.####



Original Message:

I have a problem with my jewel 4800 scsi scanner. It was sold by Primax and 
produced from TECO as far as I know. The scanner is recognized but not 
detected .. I hope that some one has a hint for me how I get this scanner to 
work..

That is what find-scanner says:
find-scanner: found scanner "Primax Jewel 1.01" at device /dev/sg1
I have set the softlink and the rights

That is from  /proc:
# cat /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 00 Lun: 00
  Vendor: IBM      Model: DCAS-34330       Rev: S65A
  Type:   Direct-Access                    ANSI SCSI revision: 02
Host: scsi0 Channel: 00 Id: 04 Lun: 00
  Vendor: Primax   Model: Jewel            Rev: 1.01
  Type:   Scanner                          ANSI SCSI revision: 02
Host: scsi1 Channel: 00 Id: 00 Lun: 00
  Vendor:    LG    Model: CD-ROM CRD-8320B Rev: 1.28
  Type:   CD-ROM                           ANSI SCSI revision: 02
Host: scsi1 Channel: 00 Id: 01 Lun: 00
  Vendor: HP       Model: CD-Writer+ 8200  Rev: 1.0f
  Type:   CD-ROM                           ANSI SCSI revision: 02

That is from scanimage -L:
No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
find-scanner tool (if appropriate). Please read the documentation which came
with this software (README, FAQ, manpages). -> Done, but no luck.

It seems that it scanner is not supported.... Bad luck? But maybe there is a 
work-a-round? Are there simmilare products which drivers I may can try?

Thanks a lot 
Michael :-)


Previous by date: 7 Sep 2001 19:35:44 -0000 Re: Primax Scanner specifications, ricardo marcelo da silva
Next by date: 7 Sep 2001 19:35:44 -0000 Re: please comment..., Christian Ordig
Previous in thread:
Next in thread: 7 Sep 2001 19:35:44 -0000 Re: please comment..., Christian Ordig


Powered by ezmlm-browse 0.20.