[<<] [<] Page 1 of 1 [>] [>>] | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Subject:
Scaner Genius ColorPage-Vivid Pro
From: Antonio Carlos Ribeiro Nogueira ####@####.#### Date: 29 May 2001 14:34:44 -0000 Message-Id: <3B13B3F8.1986672@sinmec.ufsc.br> Dear friends I have a Genius ColorPage-Vivid Pro (Primax Direct 600, if I am not wrong) and I have installed the primax_scan-0.93beta3 to try to make this scanner work. Well, the instalation was made without any errors messages, but when I start the program typing: primax_scan -C 0 -S 150 -s 15 -d 8x8 -f teste.tiff the scanner lamp travells a few shorts stop and go distances and then it travells a very short discance and stops. When I change the size of the scannned area to -d 80x80, the distance traveeld by the lamp is a little bit longer (about 1.18in) and then it stops without to cover the whole area to be scanned. Furthermore, even I had select -s 15, the lamp runs very very slowly (I don't know what units does 15 represents). The command to turn on or off the lamp is working fine... :o) (what is good... worst would be if the lamp didn't turnned off...). When I turn off the lamp I receive a message saing me: "Looks like a Primax Colorado Direct 600". Do you have any idea what may be happening? I would like to thanks in advantage. Sincerely Antonio Carlos | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
[<<] [<] Page 1 of 1 [>] [>>] |