gnupic: Re: [gnupic] Cod file question
Subject:
Re: [gnupic] Cod file question
From:
Walter Banks ####@####.####
Date:
16 May 2008 11:51:40 -0000
Message-Id: <482D751C.A30E503D@bytecraft.com>
The original .COD file supported variable names of 12 or 13 characters. Later
support was added to support 32 byte names. To ensure backwards compatibility
the COD file has both entries in the code_directory
symtab , symend is the short symbols
Lsymtab, Lsymend is the long symbol table
The message you are seeing is the long symbol table doesn't point to any information.
Walter Banks
Byte Craft Limited
Phil wrote:
> Thank you for reading this.
>
> I've been using pikdev to create projects but have never understood how to
> overcome the following message when gpsim starts:
>
> "No long symbol table info"
>
> A cod file is generated but apparently without a symbol table. How to I
> correct this? A gplink option? If it is, how do I add the option to pikdev?
>
> --
> Regards,
> Phil
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: ####@####.####
> For additional commands, e-mail: ####@####.####
