nanogui: Using own true type font with Nano-X
Subject:
RE: [nanogui] Using own true type font with Nano-X
From:
"Martin Kajdas" ####@####.####
Date:
3 Oct 2006 18:05:22 +0100
Message-Id: <CF2BB830A62F914F848E5AD5FFF57AC229156F@mkmail.MKPROD.COM>
Show me the lines you put in fonts.dir for this font; also did you
change the number at the top of fonts.dir?
Martin
-----Original Message-----
From: Kiran Mahajan ####@####.####
Sent: Tuesday, October 03, 2006 9:25 AM
To: Greg Haerr; Nano-X
Subject: Re: [nanogui] Using own true type font with Nano-X
thanks!
I tried with the one font first. I tried with the font dvsr0ntt.ttf.
name of this font was in upper case. I checked with it by keeping it in
upper case, then after getting error I renamed it to lower case.
after doing with this font i tried with other font (DVWSR0NT.TTF) also
for sake doubt! but end up with same result. I have made entry for both
the fonts in the font.dir.
Is there any other file where I need to make entry for those fonts?
thanks and regards,
Kiran
On Sat, 2006-09-30 at 08:24 -0700, Greg Haerr wrote:
> The above fonts are different names.
>
> My suggestion is to work only with ONE font, and
> debug the problem one font at a time. The
> TTF system works, so its likely a font naming or
> upper/lower case problem. Change your system
> to use only a single font. Perhaps the font conversion
> utility is putting the font name inside the font file with
> the wrong case?
>
> Regards,
>
> Greg
---------------------------------------------------------------------
To unsubscribe, e-mail: ####@####.####
For additional commands, e-mail: ####@####.####