nanogui: nanox not working for framebuffer
Subject:
Re: [nanogui] nanox not working for framebuffer
From:
"daniel" ####@####.####
Date:
10 Jul 2001 06:02:37 -0000
Message-Id: <004801c10905$bec19a50$0300c0a8@biji>
hehe, i just resolve this problem 1 month ago.
(1) custom installation of linux with kernel development and linuxconf
(2) run "make menuconfig" in /usr/src/linux/
(3) enable MTRRs in menuconfig's processor unit ( intel platforms)
(4) Enable "prompt for development andor incompleter drivers" in the Code Maturity Level menu
(5) Go into console deivers menu enable the following
VGA TEST CONSOLE
VIDEO SELECTION SUPPORT
SUPPORT FOR FRAMEBUFFER DEVICES
ADVANCED LOW LEVEL DRIVERS
SELECT mono, 2,4,6,8,16,24,32bpp packed pixel drivers
(6) run "make dep" in /usr/src to rebuild kernel
(7) modify /etc/lilo.conf to include the VGA=788 parameter and run /sbin/lilo.
(8) Reboot the kernel
then u will see that small cute little Penguin logo , that means u are success !
Regards
Daniel Wang
Bijitec
Tel:(8621)58369852
Fax:(8621)58369852
####@####.####
----- Original Message -----
From: "ritubhalla" ####@####.####
To: "Krist" ####@####.#### ####@####.####
Sent: Tuesday, July 10, 2001 12:11 PM
Subject: [nanogui] nanox not working for framebuffer
> hi,
>
> I have configured my kernel and nanox for frambuffer but when I start
> the nanox I get an error "
>
> /dev/fb0 not found .Check your kernel config".
>
> Any pointers in this direction?
>
> Regards,
>
> Ritu
>
>
--------------------------------------------------------------------------------
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: ####@####.####
> For additional commands, e-mail: ####@####.####
