[<<] [<] Page 1 of 1 [>] [>>] | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Subject:
Calibration
From: "Leah Burstein" ####@####.#### Date: 1 Aug 2001 20:34:56 -0000 Message-Id: <005001c11aca$3c4782c0$7001010a@homeGopher.com> Hello, Can somebody explain how to use tpcal program? An attempt to run it on iPAQ gives a message "Bus Error". Thank you, Leah. | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Subject:
calibration
From: victor ####@####.#### Date: 16 Aug 2001 13:47:55 -0000 Message-Id: <3B7BCEF4.DE928FC1@aaeon.com> Hi, I am now using mou_ipaq driver for my touch screen. But I can't access some part on the side of my microwindow, and I think I need to do the calibration. But in the mou_ipaq.c, I don't see a function to read in the value-file after calibration like /etc/pointercal. Nor did the file include some transformation function. Do you know how should I do the calibration with this?? The calibration program I use is tpcal and it returns 7 numbers. thank you Vic | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Subject:
Re: [nanogui] calibration
From: Jordan Crouse ####@####.#### Date: 16 Aug 2001 19:50:26 -0000 Message-Id: <01081613392502.02056@cosmic> On the Ipaq, much of the calibration is handled by the kernel driver and the touchscreen hardware. You simply determine the minimum and maximum values for both x and y and pass them to the kernel. Check www.handhelds.org for a few Ipaq calibrators. Jordan On Thursday 16 August 2001 07:47, victor mentioned: > Hi, > I am now using mou_ipaq driver for my touch screen. But I can't access > some part on the side of my microwindow, and I think I need to do the > calibration. But in the mou_ipaq.c, I don't see a function to read in > the value-file after calibration like /etc/pointercal. Nor did the file > include some transformation function. Do you know how should I do the > calibration with this?? > The calibration program I use is tpcal and it returns 7 numbers. > > thank you > > Vic > > --------------------------------------------------------------------- > To unsubscribe, e-mail: ####@####.#### > For additional commands, e-mail: ####@####.#### | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
[<<] [<] Page 1 of 1 [>] [>>] |