nanogui: Thread: connect serial mouse problem

Hi, 
in order to use serial mouse on microwin, I set the DTR and RTS pin to
high for the mouse to have power. But after I plug it in after running
microwindow, the curser seems to runnning around and clicking randomly
when I move the mouse. Do you have any idea where might went wrong??

thank you

> -----Original Message-----
> From:	victor ####@####.####
> Sent:	Thursday, August 16, 2001 4:58 PM
> To:	####@####.####
> Subject:	[nanogui] connect serial mouse problem
> 
> Hi, 
> in order to use serial mouse on microwin, I set the DTR and RTS pin to
> high for the mouse to have power. But after I plug it in after running
> microwindow, the curser seems to runnning around and clicking randomly
> when I move the mouse. Do you have any idea where might went wrong??
	[Simon Wood]  
	It looks like you might be using the wrong serial protocol
	for the mouse you have.

	Are you using gpm to re-export the mouse information? if so
	change the type in the gpm command to '-t ms' (or whatever).

	If you're using the 'mou_ser.c' driver check the start of the 
	file and ensure that the correct TYPE and PORT are set for
	your hardware.

	Cheers,
	Simon W,

: in order to use serial mouse on microwin, I set the DTR and RTS pin to
: high for the mouse to have power. But after I plug it in after running
: microwindow, the curser seems to runnning around and clicking randomly
: when I move the mouse. Do you have any idea where might went wrong??

Likely you need to set the mouse driver to match the hardware
mouse protocol coming over the wire.  Look at drivers/mou_ser.c
for more details.

Greg