[<<] [<] Page 1 of 1 [>] [>>] | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Subject:
saving nxcal settings
From: tj ####@####.#### Date: 31 May 2004 04:50:54 +0100 Message-Id: <40BAAB82.7000703@comcast.net> Where do you save the output of nxcal so it can be found by nano-X? I found the filename /etc/ts.conf in drivers/yopy.c, but running nxcal -F -d /etc/ts.conf But, then restarting nano-X I still have to run nxcal again in order to get the cursor to track right again. tj | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
[<<] [<] Page 1 of 1 [>] [>>] |