nanogui: Thread: Regarding Cross Compilation - Endianess

Hi all,
	I am trying to use microwindows for Arm with Big endian support. I cross compiled microwindows. 
	I am getting the following warning,
		"#error MW_CPU_BIG_ENDIAN and your OS disagree about your CPUs byte-order. Did you accidentally set BIGENDIAN in the config file?"

	I checked basically it includes "endian.h" from "/usr/include" (i.e i386 version). 
	
	Does it include the correct file? I think that the file "endian.h" has to be included from the include directory available in the cross tool chain....?

	Could any one give suggestion on this?

Thanks in Advance
O.Srinivasan
	

************************************************************************
This email message is for the sole use of the intended recipient(s)
and may contain CONFIDENTIAL and PRIVILEGED information.
Any unauthorized review, use, disclosure or distribution is prohibited.
If you are not the intended recipient, please contact the sender
by reply email and destroy all copies of the original message.
************************************************************************



#####################################################################
This Email Message is for the sole use of the intended recipient(s) and May contain CONFIDENTIAL and PRIVILEGED information.
LG Soft India will not be responisible for any viruses or defects or
any forwarded attachements emanating either from within
LG Soft India or outside. Any unauthorised review , use, disclosure or distribution is prohibited. If you are not intentded
recipient, please contact the sender by reply email and destroy all
copies of the original message.
#####################################################################

From: Srinivas O ####@####.####

> I think that the file "endian.h" has to be included from the include
directory available in the cross tool chain....?

You are correct. The files on your local machine are tailored for its arch.
-Alex.

: "#error MW_CPU_BIG_ENDIAN and your OS disagree about your CPUs byte-order.
: I think that the file "endian.h" has to be included from the include
directory available in the cross tool chain....?

Yes, this is correct.  The config file should be setup so that your
cross-compiler uses includes like #include <endian.h> from its
cross-include directory.

Regards,

Greg