primax: Primax Colorado D600 Support ?
Subject:
FW: Re: Primax Colorado D600 Support ?
From:
Christian Ordig ####@####.####
Date:
12 Jun 1999 14:35:02 -0000
Message-Id: <XFMail.990612160319.chr.ordig@gmx.net>
Marco forgot to send it to the list, too...
-----FW: ####@####.####
Date: Sat, 12 Jun 1999 11:21:49 +0200
From: Marco Foglia ####@####.####
To: Nicolas Delisle ####@####.####
Subject: Re: Primax Colorado D600 Support ?
Cc: ####@####.####
Nicolas Delisle wrote:
> It looks like it is the time for me to expose my tests.
>
> I have a Storm Totalscan scanner. From the FCCID, and after taking a
> careful look on the Primax nederlands page, it is very similar to a
> Colorado D600 (600x1200ppp, 30bits). In fact, the Primax Colorado D600
> driver does work completely with the Totalscan (on Windows NT).
>
> So I have tried the linux driver, and even if it is not working
> completely (scan results give black images), hacking just a little bit
> in the code allows to switch the lamp on/off and to drive the CCD at the
> right positions...
>
> In any case, I am ready to test (and even hack if necessary) any piece
> of code that have a chance to work...
Hi,
maybe some more technical details will help you a little bit.
If you can turn on/off the lamp the wakeup sequence was successful.
This means the win driver is using vpmxd.vxd and your scanner is
quite compatible to the D300. Resolutions are different, so try to
adjust x_/y_table and calibration_table. The setup of the ADC is also
of importance. Try different values.
The part numbers of the ICs in your scanner would be a good
information for me. Especially the ADC and the central ASIC.
It would be great if you could look them up.
Marco
--------------End of forwarded message-------------------------
