primax: D600 Calibration Problem?
Subject:
D600 Calibration Problem?
From:
"Mike Rothon" ####@####.####
Date:
4 Feb 2002 14:07:55 -0000
Message-Id: <014f01c1ad84$a41bfaf0$7d01a8c0@mike>
I have had some success with my D600 (I am guessing its a 30 bit) with both
primax_scan and primaxd except for the following:
primax_scan:
==========
Without the -o the scan head moves forward an inch from its current position
and then sits there. I have traced the code and the problem is in
read_calibration_data - the while condition is never met.
If I specify the -o switch the scan works fine (but is a little dark).
primaxd:
=======
If I change RESOLUTION to 600 and start a preview scan in SANE, the scanner
moves about an inch and then SANE locks up. I haven't traced this through,
but suspect the problem is similar, the code layout has changed slightly,
but the functionality is the same.
Leaving the RESOLUTION at 300 causes only a 1/4 of the page to be scanned
(not surprisingly) and the whole scan has a yellow tint.
All help is greatly appreciated,
Kind regards,
Mike.