primax: Colorado D600 is working !
Subject:
Re: Colorado D600 is working !
From:
Marco Foglia ####@####.####
Date:
14 Oct 1999 13:16:22 -0000
Message-Id: <3805D614.E083123@psi.ch>
Romain Oddoart wrote:
> But I have one problem : the lamp doesn't come back to its initial position, and
> stays where it is. So the second scan isn't working, because the lamp start from
> the middle of the page and blocks when is at the end of the page. I tried to
> initialize this under windows, but the problem is the same : No return to the
> reference point, and the moter is blocking in the bottom of the page. I spent 2
> or 3 hours to try to solve this problem. I acheive once, unplugging the power
> and the parrallel port (but I think I was Lucky at this time). Now the scanner
> doesn't work since yesterday night, even under windows.
I have not seen such a behavior up to now. Sounds quite strange. At
least it
should work under Windows.
You could try to write a carrige-move-back-only program. Have
a look at the code.
Just some remarks about the "bad capacitance discharge effect". You
should unplug even the parallel port cable. I have seen the scanner
working with no real power supply as long as you don't turn on or move
the lamp. It gets the power from the computer over the paralell port.
Marco
--
Marco Foglia | Paul Scherrer Institut | phone +41 56 310 36 39
| CH-5232 Villingen | ####@####.####
-------------------------------------------------------------------
#include <math.h>
main(){int i=5;for(;i;)printf("%c\n",(int)(81+7.3*sin(i---5.75)));}