nanogui: touch screen
Subject:
Re: [nanogui] touch screen
From:
Jordan Crouse ####@####.####
Date:
15 Aug 2001 16:08:38 -0000
Message-Id: <01081510085007.21329@cosmic>
If you are getting mouse clicks then you are using the correct driver. Now
you definately need to calibrate to get accurate button clicks There are
several calibration programs available, check www.handhelds.org for more info.
Jordan
On Wednesday 15 August 2001 10:04, victor mentioned:
> Hi,
> I found out that if I change the screen_width and height in config, I
> can get a resonable position on my screen using mou_ipaq driver. But I
> have a problem that the "click" event is not very cleanly recongnize.
> It's very hard for me to close the pop up window when I click the x spot
> on the upper-right of the window. Do you have any idea to fix it??
>
> And should I do the calibration? or just change the screen width and
> height setting for the correct position.
>
> thank you.
>
> Jordan Crouse wrote:
> > There are generally two types of Strongarm touchscreens. Most strongarm
> > devices (I would say probably about 80%) use the UCB1x00 (usually the
> > UCB1200). For these devices, use the ADSMOUSE. I have only seen one
> > Strongarm device that does not use the UCB1x00, and thats the Ipaq. Alot
> > of it depends on which touchscreen drivery you use in the kernel. If you
> > use the h3600_ts driver, then use IPAQMOUSE, otherswise if you use
> > ucb1200_ts, then use ADSMOUSE.
> >
> > Jordan
> >
> > On Tuesday 14 August 2001 15:27, victor mentioned:
> > > Hi,
> > > I am using a touch screen(DYNAPRO 95659) connected to my arm board to
> > > access microwindows. Do you know which driver in microwindows should I
> > > choose? Or where in the driver files of microwindows should I change?
> > > I got a mouse error everytime I touch my screen.
> > > But if I change the ipaq mouse driver a little bit, I can still access
> > > the window with some kind of "shrinking" mapping so I am sure it should
> > > be able to work with correct touch screen driver on microwindow.
> > > Do you have any ideas, thanks??
> > >
> > > vic
> > >
> > > ---------------------------------------------------------------------
> > > To unsubscribe, e-mail: ####@####.####
> > > For additional commands, e-mail: ####@####.####
> >
> > ---------------------------------------------------------------------
> > To unsubscribe, e-mail: ####@####.####
> > For additional commands, e-mail: ####@####.####
