nanogui: Re: _X11TransSocketUNIXConnect
Subject:
Re: [nanogui] _X11TransSocketUNIXConnect
From:
"Carlos Dri" ####@####.####
Date:
8 Feb 2002 22:00:04 -0000
Message-Id: <005a01c1b0eb$a9472620$0a01010a@systelab.com>
Ok, the problem was I didn't start X11 before starting nano-x
Thanks!
----- Original Message -----
From: "Jordan Crouse" ####@####.####
To: "Carlos Dri" ####@####.#### ####@####.####
Sent: Friday, February 08, 2002 6:42 PM
Subject: Re: [nanogui] _X11TransSocketUNIXConnect
> The most important question is this:
>
> Do you want to run microwindows on the framebuffer, or do you want to run
it
> under X11?
>
> If you want to run it on the framebuffer (without X), you will need to
> compiile it for the framebuffer and include the correct mouse stuff.
>
> if you want to run it on X11, then you have to start X11 before you can
use
> the server.
>
> Jordan
>
> On Friday 08 February 2002 12:34, Carlos Dri mentioned:
> > Hi,
> >
> > I've "untared" microwindows-0.89pre8, and when I started nano-X, i
received
> > the following error:
> >
> > _X11TransSocketUNIXConnect: Can't connect: errno = 111
> > Cannot initialise keyboard
> >
> > I've followed step by step the "Introduction to Microwindows Programming
by
> > Gregory Haerr" article, and I'm using X11. So it seems not to be a
nano-X
> > problem, but X11......
> > When I do startx or X, the server starts ok.
> >
> > Any comments?????
> >
> >
> > ---------------------------------------------------------------------
> > To unsubscribe, e-mail: ####@####.####
> > For additional commands, e-mail: ####@####.####
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: ####@####.####
> For additional commands, e-mail: ####@####.####
>
>
