nanogui: Cann't build .90 when TUXMOUSE = Y
Subject:
Re: [nanogui] Cann't build .90 when TUXMOUSE = Y
From:
"Greg Haerr" ####@####.####
Date:
19 May 2004 02:05:17 +0100
Message-Id: <011101c43d3d$60273c60$3aba46a6@xmission.com>
: I boot the device and there is Tux in the upper left hand corner with
: the flashing cursor beneath him. I then run nano-X and the screen goes
: black, like it should, But, you still have the flashing cursor where it
: was previously before nano-X was started. I then run my app which draws
: a full screen bitmap as the background and writes some text on the
: screen. The flashing cursor is still there, flashing that section of the
: bitmap. And then after about 6.5 minutes the screen goes blank.
:
: This does not happen under 0.89. Except for wrong chars in the text
: (previous messages about .pcf fonts), everthing else is fine. No
: flashing left over cursor and no screen blanking after 6.5 minutes.
:
Change the setting of HAVETEXTMODE in the config file. This
was moved into the config file from drivers/scr_fb.c, this is likely
your problem.
Regards,
Greg
