nanogui: Cann't build .90 when TUXMOUSE = Y
Subject:
Re: [nanogui] Cann't build .90 when TUXMOUSE = Y
From:
tj ####@####.####
Date:
19 May 2004 15:02:14 +0100
Message-Id: <40AB68D6.4040008@comcast.net>
That fixed it. Thank you.
0.90 now seemd to be working gret with pcf fonts, etc. So goodbye to
0.89, I hope.
Thanks again.
tj
Greg Haerr wrote:
>: I boot the device and there is Tux in the upper left hand corner with
>: the flashing cursor beneath him. I then run nano-X and the screen goes
>: black, like it should, But, you still have the flashing cursor where it
>: was previously before nano-X was started. I then run my app which draws
>: a full screen bitmap as the background and writes some text on the
>: screen. The flashing cursor is still there, flashing that section of the
>: bitmap. And then after about 6.5 minutes the screen goes blank.
>:
>: This does not happen under 0.89. Except for wrong chars in the text
>: (previous messages about .pcf fonts), everthing else is fine. No
>: flashing left over cursor and no screen blanking after 6.5 minutes.
>:
>
>Change the setting of HAVETEXTMODE in the config file. This
>was moved into the config file from drivers/scr_fb.c, this is likely
>your problem.
>
>Regards,
>
>Greg
>
>
>
