plustek: load pt_drv failed for 9639T/linux suse8
Subject:
Re: load pt_drv failed for 9639T/linux suse8
From:
Dominique ####@####.####
Date:
4 Jul 2002 06:33:20 -0000
Message-Id: <Pine.GSO.4.43.0207040816100.10895-100000@eflamm.ee.ethz.ch>
Dear Gerhard,
Yes, I actually did have EPP+ECP in BIOS, which worked under windoze.
Having switched to linux I didint think of it any longer. Switching to
EPP made "make load" work without problems.
I made a quick scanning test and it scanned 4 of 5 images OK, failed to
scan 1 of 5. This one unlucky time the lamp got stuck and was going ~1cm
there and back. It was the lower part of the scanner and resolution
300DPI. Dont know what happened.
Thank you for support and plustek drivers!
ciao
Dominique
> > Hint: insmod errors can be caused by incorrect module parameters,
> > including
> > invalid IO or IRQ parameters
> >
> > and loading (insmod) failes:
> >
> > pt_drv.o: insmod
> > pt_drv.o failed
> Well if you had browsed carefully enough, you might had noticed,
> that we need more information why the pt_drv refuses to load.
> One of the most possible reasons is, that you're parport is not set
> to EPP in the BIOS. Check this! If you're sure that this is not the problem,
> enable the drivers debug messages:
> make clean
> make DEBUG=y all
> [as root]
> make install
> make load
> dmesg
>
> We need this output...
> Gerhard
> -------------------------
> gerhard AT gjaeger DOT de
