plustek: CanoScan N650U
Subject:
Re: CanoScan N 650U
From:
Roger Skildum ####@####.####
Date:
28 Dec 2002 19:18:43 -0000
Message-Id: <3E0DF7AC.4010704@axs.net>
Hi Jaeger,
First thanks for responding. To be more specific, I have tried a bunch
of stuff but for my current configuration: I have sane-backends and
sane-backends-devel 1.0.8-5 via RH RPM's. Am totally confused as to if
I need to remove these and rebuild from a Tar ball or just need to
install the driver. By the way I have already tried removing them and
rebuilding. But could not even get started for some reason. I have
sane-backends-1.0.9.tar.gz and pustek-module-o_42_9.tar.gz downloaded.
Like the Plustek-USB.tx says, I unpacked the sane-backends to my
working directory and then it says to goto sane-1.0.8/sane-backends.
There is no / sane-backends so assumed it meant /backend. Went there
and unpacked pustek-module-o_42_9.tar.gz. Next it says to d a
./configure and when I do I get a : bash: ./configure: No such file or
directory. So that is where I am right now.
I noticed that i have a /etc/sane.d/pulstek.conf file, is it possible
that I just need to configure what I have?
Thanks again
Roger
Jaeger, Gerhard wrote:
>Hi Roger,
>
>can you be more specific please!
>The few steps to patch SANE are described in
>Plustek-USB.txt within the tar-ball. There are also some
>words about the USB setup.
>One common pitfall is an old SANE installation that might
>interferes with the one that you have installed...
>
>Gerhard
>
>On Friday, 27. December 2002 17:16, Roger Skildum wrote:
>
>
>>Hi All,
>>I am not sure if this is the place to ask this or not. I am running Red
>>Hat 8.0 and am trying to get my CanoScan N 650U to work. According to
>>the Sane supported scanner list it is supported with the plustek driver.
>> Is the a current step by step guide? I have tried everything I have
>>found but all seem to be out of date and the Instructions in The Tar
>>ball just don't seem to work for me. Any help would be appreciated
>>Thanks Roger
>>
>>
>>
>
>---------------------------------------------------------------------
>To unsubscribe, e-mail: ####@####.####
>For additional commands, e-mail: ####@####.####
>
>
>
>
