primax: Primax Colorado D600 Support ?
Subject:
Re: Primax Colorado D600 Support ?
From:
Marco Foglia ####@####.####
Date:
15 Jun 1999 14:33:44 -0000
Message-Id: <376662FE.70D9E03E@foglia.org>
Colin Muller wrote:
> - When I specify, say, 6 x 8 inches at 100dpi, the image area scanned is
> (as I mentioned) really 3x4 inches, BUT the resolution is actually 200
> dpi and I end up with a 600x800dpi image - I suppose that's another
> side-effect of the changes I made to the constants.
Did you change X_/Y_RESOLUTION to 600? This might solve the problem.
> - The scan seems to start a little bit before the clear glass area of
> the flatbed - and I think it then also ends a bit before the end of the
> specified area. Some sort of offset may be needed there.
If Y_RESOLUTION is set to the correct value the lamp should move out
of the calibration area (move_carrige_forward(0.42) inside scan()).
You will see the calibration area if you open your scanner. It is
white with a black line. This to-and-fro of the win driver at the
beginning of every scan is the calibration procedure (3 scans).
Marco
