primax: Primax Colorado D600 Support ?
Subject:
Re: Primax Colorado D600 Support ?
From:
Christoph Adomeit ####@####.####
Date:
15 Jun 1999 21:59:18 -0000
Message-Id: <199906152145.XAA03308@bigcomm.niederrhein.de>
> This is just to confirm that changing the relevant three lines in the
> code to these:
>
> static const int x_table_size = 0x13DC;
> static const int y_table_size = 0x17BA;
> static const int calibration_table_size = 0x3BC4;
>
Hmm,
my D600 doesn't say anything, even after changing the above
lines. The Problem might even be with my kernel/ or hardware
setup. I enabled SPP/EPP in my Bios, but when I run
primax_scan -lon I receive the following message:
parse_options:
lamp: on
dimension: 0x 0 pixel
parse_options: switching lamp
Probing port 0378
SPP port present
PS/2 bidirectional port present
EPP 1.9 with hardware direction protocol
:-(
Scanner did not switch to EPP mode.....not compatible?
Any ideas what I can try ? What modules besides parport
should be loaded ? BTW: I still run a 2.1.132 kernel on
this machine....
Thanks
Christoph