nanogui: Nano-X stays at command prompt
Subject:
Re: [nanogui] Re: Nano-X stays at command prompt
From:
Patrick Boyd ####@####.####
Date:
2 Nov 2005 22:44:44 +0000
Message-Id: <f047f77d0511021444v4f5a7cd7y32b58e0b38c8bcc9@mail.gmail.com>
Ok, my problem was it wasn't initializing the mouse... however the
susequent prompt was over writing this error message... probably a bug
in busybox.
However, now I'm having a new problem. I can run nano-X by itself and
I get a blank screen with a mouse cursor on it. I cannot move the
cursor (I'm using the SERMOUSE driver) and I cannot exit the screen.
Also if I run nano-X with anything else it stays at the text console,
prints out some lines of text from the process I'm running with nano-X
and then hangs there. Any ideas?
Patrick Boyd
On 11/1/05, Greg Haerr ####@####.#### wrote:
> > If I do that it just sits at the prompt for a minute and then gives me
> another prompt. Again no error messages or anything.
>
> When nano-X starts, it clears the text/graphics screen.
>
> Perhaps set HAVETEXTMODE to another value. Make sure
> kernel is running in graphics mode.
>
> Regards,
>
> Greg
>
